SATELLITE FINDER KIT SIGNAL METER LNB SATELITE COMPASS POWER SUP, Electorica

SATELLITE FINDER KIT SIGNAL METER LNB SATELITE COMPASS POWER SUP

Price :

$23.99

Quantity :

Description

HIGH QUALITY SATELLITE FINDER METER KIT

WITH 22K AND HORIZONTAL AND VERTICAL LIGHTS

This satellite finder works with every satellite system

DISH NETWORK - DIRECTV - BELL EXPRESS VU - FTA - FREE TO AIR - SHAW - ..

you can now install your dish by yourself.

100% Brand New!

5 YEARS WARRANTY

Key Features/Description:

Rotating Bezel Bi-directional

Climate Capacity -50 degree to + 65 C degree

Frame Materials Cast Aluminum

Waterproof Yes

Condition New

Dial Readings Degree and mils

Casting Aluminum/plastic

Damping Process LIQUID FILLED

COLOR BLACK OR GREEN

Measurement Ruler markings

Input Frequency: 950 ~ 2300 MHz, Works With Every satellite out there
Completely Lighted With Audio Tone
Power: 13-18V supplied by Receiver OR BATTERY
Size: 77 x 60 x 28 MM
Instructions Included
COMPASS INCLUDED
POWER SUPPLY INCLUDED (BATTERIES NOT INCLUDED)

Instructions:

SATELLITE FINDER OPERATION:

Unplug the receiver from the wall.
Remove the coax from your LNBF.
Connect the coax to the meter to the connection that says "TO REC".
Using a jumper coax connect to the side of the meter that says "TO LNB".
Connect the other end of the jumper coax to the LNBF.
Plug in and power up your receiver.
Adjust the signal level knob on the front of the meter so the reading is below 5 on the scale.
Do a rough adjustment for the azimuth and elevation of the dish to get a starting point. (Using the compass)
With your signal level at or below 5 on the meter, start to adjust the dish very slowly while watching the meter.
Power down the receiver by unplugging the power cord.
Remove the meter and re-connect the coax from the receiver to the LNBF.
You are now ready to power up your receiver.